Processor or Memory Board Installation (Netfinity 7000 - 8651)

Processor or Memory Board Installation

•  Processor or Memory Board Removal

To reinstall a processor or memory board:

1.  Locate the appropriate processor-board or  memory-board connector on the system board.
    (Refer to the illustration in 'Processor or Memory Board'.
2.  Hold the board that you are installing by the two corner latches -6-.
3.  Slide the board into the appropriate slot guides.

   NOTE: Be sure the component side of the primary  processor board -4- is facing toward the adapter  cards and the component side of the secondary  processor board -5- is facing toward the memory board -3-

     Make sure you orient the board correctly before  latching it into its connector on the system board.  Failure to do so could damage the board or the connector on the system board.

4.  Rotate the two corner latches on the top of the board  until the latches are aligned with the top edge of the  board (closed position) and the board is locked into place.

     When you install processor boards or memory  boards in the server, be sure that they are completely and correctly seated in the  system-board connectors before you apply power. (The latches on the boards will be  horizontal.) Incomplete insertion might cause damage to the system board or the board that  you are installing.

5.  Reinstall the board-support panel -2-.
   1.  Align the board-support panel so that the tabs on  the rear edge of the panel fit into the guide slots.
   2.  Close the panel. Check to make sure that the  boards in the slots under the panel are aligned  with the scribe marks -7- on either side of the  holes in the center of the panel.
   3.  Tighten the screws -1- on the board-support panel.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.