Processor or Memory Board Removal (Netfinity 7000 - 8651)
Processor or Memory Board Removal
To remove one of the processor boards or the memory board:
- Power-off the server and peripheral devices and
disconnect all external cables and power cords, then, remove
the top cover (see 'Cover (Top)').
- Remove the board-support panel:
(Refer to the illustration in 'Processor or Memory Board'.
- Loosen the screws -1- on the board-support
panel -2- and remove the board-support panel
by lifting it and pulling the edge away from the
three slots at the back of the chassis.
- Store the panel until you are ready to reinstall it.
- Select the processor board -4- or -5- or memory
board -3- that you want to remove.
- Disconnect the processor board or memory board
from the system board by rotating the two corner
latches -6- on the top of the board outward to a
90-degree angle from the board.
- Grasp the two corner latches and carefully lift the
board out of the slot.
NOTE: Avoid touching the component and connectors on the board.
- Place the board on a flat, static-protective surface.
Back to
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.