Hot-Swap Power Supply Installation
The server comes with two power supplies. You can add a
third power supply to provide redundant power. After you
install power supplies, check the power-supply status
indicators to verify that the power supplies are operating
properly. See 'Power Supply Status Indicators' for details.
CAUTION Never remove the cover on a power supply.
Hazardous voltage, current, and energy levels are
present inside the power supplies. There are no
serviceable parts inside the power supplies.
Refer to the following illustration while perlorming the steps in this procedure.
NOTE: You do not need to power-off the server to install
hot-swap power supplies.
For proper system cooling, do not operate the server for more than two minutes without a power supply or a filler panel installed for each of the power-supply bays.
When you install a power supply. first, tighten completely the top screw that attaches the power supply to the server, then, tighten the bottom screw. Failure to do so can damage the power supply.
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.