User Password (Netfinity 7000 - 8651)
User Password
A user password is not required, but
a user password helps to protect the information stored in
the server. It allows you to enable secure mode and
write-protect the boot sector of a hard disk drive.
Write-protecting the boot sector is a form of virus
protection.
If a user password is set and then forgotten, you can clear
the password from memory using a system-board configuration switch.
To set a user password in the Setup program:
- Start the Setup program.
- Select Set User Password on the Security Menu screen.
The Set User Password screen appears.
- Type the password in the Enter New Password data field.
- Press Enter.
The cursor moves to the Confirm New Password data field.
- To verify that you typed the new password correctly,
type the password in the Confirm New Password
data field. If you did not type the correct password,
you must reenter the password in the Enter New
Password data field.
- If you typed the correct password, press Enter to save it.
The password becomes effective immediately after you save it.
Back to
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.