Running the Diagnostics / Diagnostic Mode (Server 300-Pxx)



  Running the Diagnostics / Diagnostic Mode

When you start the 'Diagnostic Test' programs from the Configuration/Setup menu, you can select the tests and a number of times the test run.

Some choices on the Diagnostic menu display a menu, so that you can further customize the test program.


NOTE:

  1.  You can only run the diagnostic tests when you start the server with the highest level password.  That is, if you enter the power-on password, and an administrator password is set, you can perform diagnostic tests.  You can only view the test results in the diagnostic log.
  2.  You might have to install a wrap connector on your active parallel or serial port to obtain accurate test results  for these ports.


Running the Diagnostics

To use the Diagnostics:

  1.  Power-on the server and watch the screen. Or, if the system is turned on already, press Ctrl+Alt+Del.
  2.  When the 'Press F1 to enter Configuration/Setup' message appears, press F1. If a  power-on or administrator password is set, the system prompts you for it.
     The Diagnostic/Setup Menu appears.
  3.  Select Diagnostic Utility, then, press Enter  The Diagnostic Utility Menu appears.
  4.  Select Run Diagnostic then press Enter The  server displays the How Many? menu:

  5.  Press Enter. The test selection menu displays.
  6.  Press the arrow keys to move between the choices on the menu. Press Enter to select  or deselect the choice.

  7.  Select Run Diagnostics. The diagnostic program then runs the test for each of the selected devices or modules.
  8.  Press Esc twice to return to the Diagnostic Utility Menu.
  9.  Select Diagnostic Log to view the results of the diagnostic tests.
  10.  Press Esc to return to the Diagnostic Utility Menu.
  11.  Press Esc to exit from the Diagnostic Utility Menu. The server restarts.


Viewing the Test Results

To view the results of the system diagnostics:

  1.  Power-on the server and watch the screen. Or if the system is turned on already, press Ctrl+Alt+Del.
  2.  When the 'Press F1 to enter Configuration/Setup' message appears, press F1. If a  power-on or administrator password is set, the system prompts you for it.
     The Diagnostic/Setup Menu appears.
  3.  Select Diagnostic Utility, then, press Enter  The Diagnostic Utility Menu appears.
  4.  Select Diagnostic Log. The server displays the test results.
  5.  Press Page Down to view any additional test results.
  6.  Press Esc to return to the Diagnostic Utility Menu.
  7.  Press Esc to exit from the Diagnostic Utility Menu. The server restarts.


Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.