Power Supply (Server 315, 325)



  Power Supply

NOTE: Verify that the voltage-select switch is set for the correct voltage. If the voltage switch is set to the wrong position, permanent damage might occur to the server when you power it on.

If the power-on indicator is not on, and the power-supply fan is not running, check the power cord for proper installation and continuity.

If the power cord is OK, either the power supply is defective or a defective device is causing the power supply to shut off. Check the power supply voltages.

The power supply is rated at 250 watts. Too many devices (adapters or hard disk drives) can cause power consumption to exceed 250 watts and cause the power supply to shut down. Remove adapters or devices to determine if this is the cause.

If the voltages are incorrect, replace the power supply. If the voltages are correct, and the Symptom-to-FRU index does not solve the problem, go to 'Undetermined Problems'

P1


 

-Lead Pin +Lead Pin Vdc Minimum Vdc Maximum
5, 6
5
6
6
1
2
3
4
Power Good
+4.8V
+11.52V
-10.8V
+5.25V
+12.60V
-13.2V


P2


 

-Lead Pin +Lead Pin Vdc Minimum Vdc Maximum
1
2
2
2
3
4
5
6
-4.5V
+4.8V
+4.8V
+4.8V
-5.5V
+5.25V
+5.25V
+5.25V


P3


 

-Lead Pin +Lead Pin Vdc Minimum Vdc Maximum
2
3
1
4
+4.8V
+11.52V
+5.25V
+12.6V


P4, P5, P6, P7, and P8


 

-Lead Pin +Lead Pin Vdc Minimum Vdc Maximum
2
3
1
4
+11.52V
+4.8V
+12.6V
+5.25V


P9


 

-Lead Pin +Lead Pin Vdc Minimum Vdc Maximum
3 1 +4.8V +5.25V

Pin. Description
2 - Power On Request
4 EPW (No connection on system board)
5 VFAN (No connection on system board)


P10, P11


 

-Lead Pin +Lead Pin Vdc Minimum Vdc Maximum
4 1 +3.3V +3.5V
5 2 +3.3V +3.5V
6 3 +3.3V +3.5V


P12


 

-Lead Pin +Lead Pin Vdc Minimum Vdc Maximum
3 1 +4.8V +5.25V

Pin Description
2 - Power On Request


Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.