Configuration Conflicts



Configuration Conflicts

The resources used by a server consist of interrupt request levels (IRQs), direct memory access channels (DMAs), I/O ports, and memory. This information is useful when a resource configuration conflict occurs.

Conflicts in the configuration occur if:


The steps required to resolve a configuration error are determined by the number and variety of hardware devices and software programs installed in the system.

If a hardware configuration error is detected, a configuration error  message appears after the server completes POST, but before the operating system starts. You can bypass the error or start one of the configuration utility programs. Use the up and down arrow keys (   and   ) to select Continue or Exit Setup, then, press Enter. Continue will start the Configuration/Setup Utilities program. Exit Setup will bypass the error and load the operating system. You can also press Esc to exit setup and load the operating system. To start the EISA Configuration Diskette, insert the diskette in the diskette drive and press Esc.

The Configuration/Setup Utility program and the EISA Configuration program configure the system hardware and PCI interrupt requests. These programs do not consider the requirements of the operating system or the application programs.


Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.