LCD Unit (TP 380Z - 2635)


LCD Unit


 

Step Size (Quantity) Torque
2 M2.5 x 6mm, nylon-coated (5) 3-4 kgcm


NOTE: Make sure you use the correct screw, and tighten all screws firmly to the torque shown in the table, if you have a torque screwdriver. Never use a screw that you removed.
Use a new one. Make sure the screws are tightened firmly.


 


When reinstalling the LCD Unit, push the cable connector straight into the socket.


 

Step Size (Quantity) Torque
3 M2.5 x 6mm, nylon-coated (1) 3-4 kgcm
5 M2.5 x 6mm, special-head (1) 3 kgcm


NOTE: Make sure you use the correct screw, and tighten all screws firmly to the torque shown in the table, if you have a torque screwdriver. Never use a screw that you removed.
Use a new one. Make sure the screws are tightened firmly.


 

* When removing the LCD, be careful not to damage the latches

Step Size (Quantity) Torque
8 M2.5 x 6mm, nylon-coated (3) 3-4 kgcm


NOTE: Make sure you use the correct screw, and tighten all screws firmly to the torque shown in the table, if you have a torque screwdriver. Never use a screw that you removed.
Use a new one. Make sure the screws are tightened firmly.

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.