LCD Unit, 10.4 SVGA (P/N 29H9227)

LCD Unit, 10.4 SVGA (P/N 29H9227)

1103A LCD Cover

NOTE: Be careful not to scratch the LCD cover when removing the screw covers 1
The LCD cover has several latches. Release these latches; then remove the LCD cover. Be careful not to break the latches.

Step Length (Quantity) Memo 2 M2.5 x 6 mm (2) 3 M2 x 5 mm (2)

Step	Length (Quantity)	Memo
2	M2.5 x 6 mm (2)
3	M2 x 5 mm (2)

NOTE: Make sure you use the correct screw when replacing.

Lift the LCD front cover, then remove the microphone cable.

When replacing Position the microphone cable as shown.below.

1103B LCD Panel, Interface Cable Assembly

LCD Cover (1103A)

NOTE: Be careful not to scratch or soil the surface of the LCD panel when replacing it.

Step Length (Quantity) Memo 1 M2.5 x 4 mm (1) 2 M2 x 4.3 mm (2)

Step	Length (Quantity)	Memo
1	M2.5 x 4 mm (1)
2	M2 x 4.3 mm (2)

NOTE: Make sure you use the correct screw when replacing.

When removing the interface cable assembly, remove the kapton tape on the cable, then disconnect the three connecters as shown.

When replacing Be careful not to place the core under the LCD panel.

The inverter card is very sensitive. Connect the interface cable as shown. Flexing the inverter card with too much force seriously damages the card.
It is not safe to touch the inverter card connecter A.
A loose or incorrect connection of the connector can cause a serious problem.

1103C Hinges

LCD Cover (1103A)
LCD Panel (1103B) (with interface cable assembly)

Step Length (Quantity) Memo 1 M2.5 x 4 mm (2)

Step	Length (Quantity)	Memo
1	M2.5 x 4 mm (2)

NOTE: Make sure you use the correct screw when replacing.

Back to

Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.