- Press and hold the F1 key,
then power-on the computer.
Hold the F1 key down until the Easy-Setup screen appears.
- Select Test and press Enter.
- Select a device and press Enter to run the test.
- The test progress screen appears.
- OK appears when the test ends without any errors.
- Start the Advanced Diagnostic test by pressing
Ctrl+A on the basic diagnostic menu screen.
- Select Tool to install the tools.
NOTE:
The following tools are required.
- FDD: Erasable 2HD diskette
- Parallel: Wrap plug (P/N 72X8546)
- Serial: Wrap plug (P/N 72X8546)
- PCMCIA: PC Test Card (P/N 35G4703)
- CDROM: Any CD (data CD is recommended)
- Select a device, press the Spacebar, and
install the tool. Multiple devices can be selected by repeating
this step.
A OK mark appears beside the selected devices.
- Select OK and press Enter
if the selection is OK.
- Select a device and press Enter to start the tests.
NOTE:
Don't touch the keyboard and
pointing device when the system board test
in running. This may cause an error.
- Select Test All to test all devices.
- Select Loop Test to run the tests in a repeated loop.
A loop option menu appears where you can select
a device loop or all-device loop.
Select a device by pressing the Spacebar.
Repeat this step to select multiple devices.
Press Enter to start the diagnostic loop.
If no device is selected,
all device tests are looped.
- To exit the loop,
keep pressing Ctrl+Pause until the test exits.
A beep sounds to notify
that the exit interrupt is sensed
by the test program.