FRU Removals and Replacements (2625)
FRU Removals and Replacements
This section contains information about removals and replacements.
- The system board is sensitive to, and can
be damaged by, electrostatic discharge. Establish personal grounding
by touching a ground point with one hand before touching these units.
An electrostatic discharge (ESD) strap must be used to establish
- Do not damage any part. Only certified trained personnel
should service the computer.
- The arrows in the 'Removals and Replacements' section show
the direction of movement to remove a FRU, or to turn a screw to release
the FRU. The arrows are marked in numeric order, in square callouts, to
show the correct sequence of removal.
- When other FRUs must be removed before removing the failing FRU,
they are listed at the top of the page.
- To replace a FRU, reverse the removal procedure and follow any
notes that pertain to replacement. See Locations for internal
cable connections and arrangement information.
- When replacing a FRU, use the correct screw size as shown in the
Before the computer is powered-on after FRU replacement, make sure
all screws, springs, or other small parts, are
in place and are not left loose inside the computer.
Verify this by shaking the computer and listening for rattling sounds.
Metallic parts or metal flakes can cause electrical short circuits.
please READ - see
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.