Module Testing Mode (2625)



Module Testing Mode

If the Quick Check does not find a problem, or you want to perform in-depth testing, the Module Testing mode provides a method to run individual tests on a single module. For example, you can run an individual test for the diskette drive, or you can the test for all selected modules.

To start the Module Tests:


  To use the IBM ThinkPad 365 Advanced Diagnostics Diskette, you must have at least 500KB of free memory. Be sure to read the README.PO file on the IBM ThinkPad 365 Advanced Diagnostics Diskette before using the following instructions.

  1.  Power-off the computer.
  2.  Insert the IBM ThinkPad 365 Advanced Diagnostics Diskette into drive A.
  3.  Power-on the computer.
  4.  Follow the instructions on the screen and proceed to the  Main Menu. Allow two to four minutes for the diagnostic  programs to load.
  5.  At the Main Menu, select Diagnostics.
  6.  At the Diagnostics Menu, select Module Tests.
  7.  At the Module Tests Menu, select the modules to test.
  8.  Use the up and down arrow keys (   and   )  to move the highlight bar from one selection to the next.
  9.  Press Enter to run the tests.
  10.  Do not press any key until prompted, then follow the instructions  on the screen.
  11.  Follow the instructions on the screen.
  12.  Select Exit.


Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.