FRU Removals and Replacements (2523)
FRU Removals and Replacements
Follow the numerical sequence in the FRU removal sequence list and in the
exploded view to remove or disconnect parts in the correct order. The
letters in parentheses in the list indicate screw
types.
See the 'Screw Size Chart', to match the letters to the correct screw type
and size before replacing each screw.
Saftey 8
Saftey 1
- Battery Pack
(To replace the backup battery, use a coin to open the backup battery door
on the bottom cover. Reset configuration after
replacing the backup battery.)
- Four Bottom Cover Screws (2-B, 2-W)
(At each corner)
- Top Cover Assembly
- One Bottom Cover Screw (X)
(At center)
- LCD and Digitizer Cables
- LCD Assembly and Shield Cover Assembly
- Switch and LED Card
- Four Shield Cover Screws (Z)
(At corners of shield cover)
Separate LCD assembly and shield cover
(Perform digitizer calibration if the LCD assembly is replaced.)
- Standby Battery
- System Power Cable
- Seven System Board Screws (Y)
- System Board
(Remove the backup battery, sub battery, DC/DC card and inverter card, and
the hard disk drive from the old system board and install them on the new
one. Check that the IC card bracket is in place before tightening the
board screws.
Perform digitizer calibration for the new system board.)
- One Screw (Y)
- Shield Kit and DC/DC Card
- Inverter Card
- Four Screws (T)
(In system board holding hard disk drive)
- Hard Disk Drive
Back to