1120 Shield Assembly



1120 Shield Assembly

 

The microphone cable can pick up electrical noise if the cable path is incorrect.

Do the following to place the cable in its correct position.
  1.  Position the cable as shown.

     
  2.  Install the shield assembly
  3.  Move the end of cable to the right

 

The following figure shows the final path of the cable. Make sure the cable is not positioned in any shaded areas.

 

Use the following table to reference when replacing parts.

Step Location (Quantity) Length
1 Shield cover (1) 4 mm
2 Shield cover (2) 6 mm
3 Shield cover (1) 14 mm
4 Shield cover (1) Flat head


NOTE: Make sure you use the correct screw. Screw Size Chart

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.