1090 Status Indicator



1090 Status Indicator


  Do not pull the status indicator cable. The cable will be damaged if the status indicator is disconnected without releasing the latch in step 2.
 

NOTE: When replacing the indicator, insert the flexible cable straight into the connector until the head of the cable stops. Slide both ends of the latches at the same time to make sure that the cable is correctly inserted.
 

Use the following table for reference when replacing parts.

Step Location (Quantity) Length
1 LED Stand off (2) 6 mm


NOTE: Make sure you use the correct screw. Screw Size Chart


Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.