1080 Keyboard Unit



1080 Keyboard Unit


Loosen the three screws 2, and push 3 to release the five top cover latches at the rear side of the system unit.

When removing the screw covers 1, use a small screwdriver.
 

The keyboard unit is connected to the system board with flexible cables. Remove the upper cover, then disconnect the cables to remove the keyboard unit as shown.

To remove the top cover, do not latch the keyboard. Lower the keyboard and remove the top cover.

  Do not pull the keyboard cables.
The keyboard cables will be damaged if the keyboard is disconnected without releasing the three latches 5
 

NOTE:
  1.  When replacing the keyboard, check that  the three cables are clean, and  inserted straight and fully into the connectors.  Slide both ends of each latch at the same time  to make sure that each cable is correctly inserted.  Go to 'Keyboard / Auxiliary Input Device Checkout' and test all keys before returning the  computer to the customer.

  2.  When replacing the top cover,  insert the four latches at the rear side of the cover  into the foot guide of the the LCD, push the right, left,  and front sides to snap it into place.


Use the following table for reference when replacing parts.

Step Location (Quantity) Length
2 Top cover (3) 4 mm


NOTE: Make sure you use the correct screw. Screw Size Chart


Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.