Ni-MH Battery Pack
Li-ion Battery Pack
NOTE: Signal lines, not used in these steps,
are used for communication between the system and the battery.
The storage switch is used to control the power to the
internal microprocessor of the battery.
The storage switch should be
set to off (0) only when the battery is going to be kept in storage
for more than two months.
If the voltage is still less than +8.0 Vdc after the recharging,
replace the battery.
If the resistance is not correct, replace the battery pack.
Terminal
Voltage (Vdc) / Signal
1
+8.0 to +16.0
2
Send
3
Thermal
4
Ground (-)
5
NC
6
NC
7
NC
NOTE:
Li-ion battery is optional for Model 755CDV.
Terminal
Voltage (Vdc) / Signal
1
+8.0 to +13.0
2
Send
3
Thermal
4
Ground (-)
5
R1
If the resistance is correct, replace the DC/DC card.
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.