2070 LCD Assembly
2070 LCD Assembly
- Two types of LCDs are available for the Model 755C: one with a contrast control
and one without. Make sure that you replace the LCD with the correct type.
- The LCD for the Model 370C does not have a contrast control.
1 When replacing the LCD
ground-terminal screw, do not pull or push the LCD cables.
2 When removing the LCD cables, pull the connector
straight up.
Incorrect handling can damage the connector.
NOTE:
For the color models, make sure
the indicator does not catch the right LCD connector
when replacing the status indicator.
3 Remove the screw.
4 Remove the right hinge cover.
5 When removing the left hinge cover,
use a small screwdriver as shown
to release the latch from the rear base cover.
Pull the hinge cover slightly upward to keep it unlatched.
6 From the front side, remove the latch
with a small screwdriver as shown to remove the cover.
Be careful not to scratch the surface of the computer
when you use a screwdriver to remove the latches.
7 Remove the four screws.
Use the following table for reference when replacing parts.
| Step |
Location (Quantity) |
Length |
| 1 |
LCD ground-terminal (1) |
4 mm |
| 3 |
LCD hinge cover, right (1) |
4 mm |
| 7 |
LCD hinge (4) |
4 mm |
NOTE: Make sure you use the correct screw. Screw Size Chart
please READ - see >>
Caring for the LCD
- When cleaning of the LCD becomes necessary,
gently wipe the LCD with a dry, soft cloth.
Do not use alcohol or detergent to clean the LCD.
- To avoid damaging the LCD,
do not scratch or apply any force to its surface.
- Do not put anything on the surface of the LCD.
Back to 
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.