2060 Status Indicator



2060 Status Indicator


 
Do not pull the status indicator cable. The cable will be damaged if the status indicator is disconnected without releasing the latch in step 2
 

The status indicator has three latches on its rear and two in its front. in step 3, do as follows:
  1.  Release the rear latches with pushing each one with your thumb,  as shown in the artwork.  (The circles in the figure show the locations  of the three latches.)
  2.  Release the front latches.
  3.  Lift the indicator.

 

NOTE: When replacing the indicator, insert the flexible cable straight into the connector until the head of the cable stops. Slide both ends of the latches at the same time to make sure that the cable is correctly inserted.
 

Use the following table for reference when replacing parts.

Step Location (Quantity) Length
1 Indicator bracket (2) 4 mm


NOTE: Make sure you use the correct screw. Screw Size Chart

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.