. Click on a
connector on the equipment to begin routing. You cannot route to or from a
piece of equipment that does not have a connector.
|
|
This task shows you how to route between equipment. | |
|
|
Enabling dynamic connectors in a component allows for automatic creation of connectors during the design process. | |
|
|
1. | Click the Route Waveguide Line
button . Click on a
connector on the equipment to begin routing. You cannot route to or from a
piece of equipment that does not have a connector. |
| 2. | Route to a connector on the
equipment where you want to end the route. Click to end routing. The
connectors you have routed to and from will disappear. The image below
shows equipment during and after routing.
|
|
