if you want to
route a piping line or click the Route I&C Loop button
to route an I&C loop.Enabling dynamic connectors in a component allows for automatic creation of connectors during the design process.
|
|
This task shows you how to route between equipment. | |
|
|
Click the Route Piping Line
button if you want to
route a piping line or click the Route I&C Loop button
to route an I&C loop. Enabling dynamic connectors in a component allows for automatic creation of connectors during the design process. |
|
|
|
1. | Click on a connector on the equipment to begin routing. You cannot route to or from a piece of equipment that does not have a connector. |
| 2. | Route to a connector on the
equipment where you want to end the route. Click to end routing. The
connectors you have routed to and from will disappear. The image below
shows equipment during and after routing.
|
|
