This procedure describes how to do measure analysis in
the video window without going to the measure window. With this
functionality, you can make the following types of measurements:
|
|||||||||||||||||||||
Complete the procedures as described in
Accessing NC Manufacturing Verification,
including:
|
|||||||||||||||||||||
|
|||||||||||||||||||||
About Video Measure Options |
|||||||||||||||||||||
The options in both Selection 1 Mode and Selection 2 Mode drop-down menus are:
|
|||||||||||||||||||||
These options can selected in any combination. Below are some of the possible selection combinations: | |||||||||||||||||||||
|