Q:
ABSTRACT: PSF/6000: Can we use a formdef to select bin 2 on a
PCL mode 3116 running via PSF/6000?
SEARCH ARG: psf/6000 3116 bin
TOPIC THREAD: PRINT
AFP
PSF6000
..
Customer is using PSF/6000 V1.2 and a 3116 (PCL mode) and read flash
regarding bin selection via FORMDEF. We tried using IBM-supplied
F1A10120 and verified that the trays are not linked on the printer,
but the job prints from tray 1 instead of tray 2 as specified in the
formdef. Shouldn't this work even though they're in PCL mode? Is
there something we should check on the printer? Can you run a test?
A:
For PCL and PPDS printers, you have to specifically enable the alternate
bins as described in Print Administration (S544-3817-02, page 175ff).
After you do that, it should work. If not please reopen.
In case you don't have the book, here's the "short version":
smit psfcfg
Show/Change Characteristics of a Printer
Bin Mapping Options (PPDS and PCL Printers Only)
(select printer name from list)
1 Lower
Change value to "yes" for "Is the bin mapping AVAILABLE?" field and
press ENTER. Then you must use psfctl -dtu to stop
and restart the printer for the change to take effect.
I hope that helps. Closing.
S e a r c h - k e y w o r d s:
AIX PSF/6000 PSF FOR AIX BIN MAPPING PCL PPDS ALTERNATE FORMDEF
WWQA: ITEM: RTA000092800 ITEM: RTA000092800
Dated: 02/1996 Category: XPSF6000
This HTML file was generated 99/06/24~12:43:31
Comments or suggestions?
Contact us