Client is running on 192.9.201.30. A gateway has 192.9.201.41 and
192.9.200.31. The xstation has 192.9.200.32. All systems are
running routed. Other xterminals similiarly configured on both
sides of the gateway work fine. Starting an xterm on the otherside
of the gateway for display on the xstation pulls a "Can't open
display" error. Ping doesn't work either. I have tried
setting the network configuration gateway without success. Any
ideas?
---------- ---------- ---------- ---------- ---------- ----------
A: Verify the following:
1) The Xstation 120 has 1.5MB system memory and is using bootfile1.
2) The Xstation Network Type has the correct address of the gateway.
smit devices
Xstation Configuration
Change/Show Characteristics of an Xstation Network Type
(Verify that GATEWAY shows 192.9.200.31 and
Subnet MASK shows 255.255.255.0)
3) The host (192.9.201.30) has a route to get to 192.9.200.31.
---------- ---------- ---------- ---------- ---------- ----------
---------- ---------- ---------- --------- ---------- ----------
This item was created from library item Q610281 SF954
Additional search words:
CLIENT CUSTORG DISPLAY DSPLY GATEWAY IRRISC IX OCT92 OZNEW RISC
SF954 SIDE XSTATION
WWQA: ITEM: RTA000027354 ITEM: RTA000027354
Dated: 11/1996 Category: RISCTCP
This HTML file was generated 99/06/24~12:43:10
Comments or suggestions?
Contact us