ITEM: F7065L

Need help separating segments on an 8250 hub.

Question:

I am operating on a 980B @ 3.2.4, and am getting ready to move some of
my network boards around.  I am trying to set up each port as a
netwrok segment so that when they are moved our changed, I can change
them per port (which I can easily check and see what tty, etc. I am
moving) rather than per board (in which case, I may be moving
different sites connected around the country, and not know which they
are).  Is this board capable of doing segmentation on a per port
basis? or am I going to be forced to do these changes per board (of
which I have three)?


Response:



Support Line: Need help separating segments on an 8250 hub. ITEM: F7065L

Dated: January 1994 Category: N/A

This HTML file was generated 99/06/24~13:30:51

Comments or suggestions?
Contact us