ITEM: CD0401L

Changed tty on /etc/ibmatl.config file, lmcp daemon fails

Response:

   Env:  4.1.4, SP2
         Tape 3434 tty attached

   Desc:  
        Caller has a 3494 attached via SCSI and a tty attaching to
        the management control program.  Caller had it attached to tty2
        before and everything was running fine.  He didn't have a tty1,
        so he deleted tty2 and reconfigured it to tty1.  Then 
        reconfigured 3494 and that all went smoothly.

   Action:  
        Now, caller has everything showing up available.
        He's got: lmcp0, rmt0, and rmt1 all available
        When he runs 'cfgmgr' to get the lmcp daemon going, he gets an
        error and the lmpc daemon won't stay running.
   

Response:

When the customer tries to start his lmcp daemon, it errors out with:

No valid library configuration defined.

Customer needed to edit his /etc/ibmatl.conf file:

it said:

3494a /dev/tty1

it needed a third field, which should be the host name of the
workstation.

he changed this to:

3494a /dev/tty1 f0

Then he reran cfgmgr and then restarted the daemon.  This worked.
Evidently he needed the third field, the identifier.

NOTE:
There are two ways to configure a library, either as a tty (above)
or as an ip address, which you would use if this were a network
connection.

Next:
CWCA




Support Line: Changed tty on /etc/ibmatl.config file, lmcp daemon fails ITEM: CD0401L

Dated: August 1996 Category: N/A

This HTML file was generated 99/06/24~13:30:18

Comments or suggestions?
Contact us