ITEM: BW6497L

HACMP: Geting save_SNMP_var on the console every 5 seconds.

 ENV:  58H  AIX 4.1.5 HACMP 4.1.1  Rotating resources

  events 4.1.1.7
  utils  4.1.1.7
  rte    4.1.1.5
  diag   4.1.1.6

 PROBLEM: Clinfo daemons are emitting the following errors to the
console every 5 seconds.  save_SNMP_var: receive buffer is full.  If
the customer starts clinfo his applications will not start.

 ACTION TAKEN:

Started HACMP without clinfo daemons.  HACMP came up fine, and the 
applications started fine.  Started clinfo once HACMP was up.  The 
errors immediately came back.  

On the node that has the service address, clstat shows searching for 
new cluster.  On the standby it shows the cluster up and stable.  
This happens regardless of which node had the service address.

HACMP itself does not seem to be an issue, because you can start
clinfo daemons from the command line with HACMP down and still get the
errors.

Removed loopback from the clhosts file, and put in the service and boot 
addresses of the cluster members.  This resolved the problem.




Support Line: HACMP:  Geting save_SNMP_var on the console every 5 seconds. ITEM: BW6497L

Dated: April 1997 Category: N/A

This HTML file was generated 99/06/24~13:30:19

Comments or suggestions?
Contact us