LED 622 then blank or LED 511 then blank
RISC SP2 high node
Customer is booting a high node from a normal thin
node and it does this LED 622 then blank or
LED 511 then blank
The customer has a ascii terminal.
LED 622 then Blank -- cfgcon command failed to run
LED 511 then Blank -- cfgcon command failed to run
Usually caused from missing device driver support for the graphic
adapter on the client system. Also if a ascii terminal is being
used it means missing Standard IO support for the serial port
for the client.
Add the filesets, reboot the server, remake
the network boot image or rebuild the boot tape.
Install these filesets
Standard I/O (dee6) Adapter Software
Standard I/O (df5f) Adapter Software
Standard I/O (fed9) Adapter Software
Standard I/O (f6fe) Adapter Software
Closing the call
Support Line: LED 622 then blank or LED 511 then blank ITEM: BU7331L
Dated: February 1997 Category: N/A
This HTML file was generated 99/06/24~13:30:19
Comments or suggestions?