ITEM: AC2690L

TELEUSE/COMBINED W/AIX WHEN EXECUTE: LDX ERROR MESSAGE

Question:
   Env: 3.2.5, Teleuse 3.0.1
   Desc: Have a written program which I am experiencing problems with
         since an upgrade to 3.2.5. Previously it was with the shared
         libraries but cleared up that problem. Now it compiles and links
         but when I run the executable get the following error messages:

                failed  to load LDX: LDX_STATIC_SIM not found
                locale not supported by Xlib locale set to C
    Action: 
        
        1) ran 'echo $LANG' was C. 
        2) Changed LANG env variable 'export LANG=En_US'
        3) ran locale and everything was set to En_US. 
        4) Verified that in /usr/lib/X11 that En_US was present. 
        5) cd /usr/lib/X11 and check for link to /usr/lpp/X11/lib/X11/lib 
           this was present. 
        6) Ran env to look at LOCPATH and NLSPATH. These were the same but you 
           did have an entry of XNLSPATH which was created for Teleuse. 

        Information states that a local environment variable XNLSPATH may be
        defined to refer to a directory supplied with the TeleUse 
        graphical toolkit. 
        The XNLSPATH should be extended to point to the standard AIX NLSPATH 
        directories in addition to the TeleUse directory.
        The installation manual for TELEUSE states that a directory 
        /X11/R15/lib/nls was to be defined in XNLSPATH.
        After unsetting this parameter, all programs worked without
        any error messages. 



Support Line: TELEUSE/COMBINED W/AIX WHEN EXECUTE: LDX ERROR MESSAGE ITEM: AC2690L

Dated: October 1994 Category: N/A

This HTML file was generated 99/06/24~13:30:30

Comments or suggestions?
Contact us