[ Previous | Next | Contents | Search ]
AIX Version 4.3 Package Guide for LPP Installation

AIXlink/X.25 Low Capacity Package

This package provides the same functionality as the AIXlink/X.25 package, but with a reduced number of available virtual circuits (4). It is intended to be a low cost product for client systems.

Fileset Names

sx25.rte AIXlink/X.25 Run-Time Environment

This fileset provides the base X.25 device drivers, configuration methods, and applications necessary to use the other AIXlink/X.25 options.

sx25.npi AIXlink/X.25 NPI and DLPI Support

This fileset provides the device driver necessary to run NPI applications.

sx25.comio AIXlink/X.25 COMIO Compatibility Support and Applications

This fileset provides the device driver and applications for the COMIO compatibility interface. This interface provides compatibility with the AIX Version 3 base X.25 product.

sx25.tcpip AIXlink/X.25 TCP/IP Support

This fileset provides support for the TCP/IP protocol running over X.25.

sx25.pad AIXlink/X.25 Triple-X (PAD)

This fileset provides PAD software supporting the X.3, X.28 and X.29 standards.

Approximate Disk Space Required

The AIXlink/X.25 Low Capacity package requires approximately 3.2 MB of disk space.

Requisite Software

Requisite software must be installed before or with the filesets you are installing from this package.

Fileset you are installing Requisite Software
AIXlink/X.25 NPI and DLPI Support AIXlink/X.25 Run-Time Environment
sx25.rte
AIXlink/X.25 COMIO Compatibility Support and Applications AIXlink/X.25 Run-Time Environment
sx25.rte
AIXlink/X.25 TCP/IP Support AIXlink/X.25 Run-Time Environment
sx25.rte
TCP/IP Client Support
bos.net.tcp.client
AIXlink/X.25 Triple-X Packet Assembler/Disassembler (PAD) AIXlink/X.25 Run-Time Environment
sx25.rte

Special Installation Notes

Stop all sx25 software before installing another version of the software. Version 4.1.2 or a higher version is required to install and run the AIXlink/X.25 product.

[ Previous | Next | Contents | Search ]