[ Previous | Next | Contents | Home | Search ]
AIX Versions 3.2 and 4 Asynchronous Communications Guide

Configuring an Asynchronous Terminal Connected to a RAN

This procedure allows you to define and configure a tty device connected to a 128-port asynchronous adapter RAN.

Prerequisites

  1. You must have root user authority.
  2. A 128-port asynchronous adapter must be installed, defined, and available.
  3. At least one RAN must be connected. See "Connecting a RAN to a 128-Port Asynchronous Adapter".
  4. Set the RAN node ID. Refer to "Setting a RAN Node Number".
    Note: Correct cabling must be used so the asynchronous terminal operates correctly on the remote asynchronous node. RJ-45 10-pin cable is recommended to support the full EIA 232 specifications.

Procedure

  1. Use the smit tty fast path to access the TTY menu.
  2. Select Add a TTY.
  3. Select tty rs232 Asynchronous Terminal or EIA 422 as appropriate for the RAN type.
  4. Make a selection from the available RANs displayed on the screen. If no RANs are displayed or if they are shown in a defined state, check the RAN configuration, cabling, and setup again.

    For this example, the following selection was made:

    sa4 Available 00-03-21 16-Port RAN EIA 232 for 128-Port Adapter
  5. In the displayed dialog fields, you can add or change the field values as needed.
  6. When you have finished, select Do.

[ Previous | Next | Contents | Home | Search ]