P/N
9114-275 ................. 33L3251 black
6094-051 ................. 41L6030
Required AIX 4.2.1 or 4.3.2
6094-040 Input Device...... 88G4596 Europe
88G4597 USA
Cable adapter...... 88G4600 9pin-to-25pin
6094-030 Input Device....... 09G3743
Signal Cable....... 39F8228
Power Cable........ 39F8302
Driver Diskette.... 09G3748
Power Supply - 120V. 6247468
Fileset............. devices.serial.sb1.X11
6094-031 Input device....... 08L0232 Not sold by IBM anymore
Signal Cable....... 08L0234
6094-600 Magellan 3-D....... 93H8631
Tranfo for 6093-011/012 6094-30
120V Power Supply.. P/N6247468
240V Power Supply.. P/N6247469
100V Power Supply.. P/N74F3089
Installation and User's Guide....... GA23-2071
Interesting RETAIN Tip: H12252
Others Info to know: 6094-030 is not supported on the Graphics Input Device Adapter
HINTS: 1) When plugged in, the spaceball beeps depending on the default mode:
2 beeps.... Standard Mode
3 beeps.... CATIA mode
4 beeps.... CAEDS mode
5 beeps.... CGS mode
2) This information is kept inside the spaceball. So, if another
spaceball is plugged on the same port, it may beep differently.
Be sure to get the mode customer needs. I have seen a customer
using CATIA and the desired mode was Standard. Both modes are
supported with CATIA.
3) To change the mode, press the Pick button and
another button as follow:
Modes
----------
STANDARD: Press the Pick button and button #2
CATIA: Press the Pick button and button #3
CAEDS: Press the Pick button and button #4
CGS: Press the Pick button and button #5
PERMANENT SAVE: Press the Pick button and button #8
after having chosen the desired mode. VERY IMPORTANT !
Spaceball can be configured as dials or tty. So, be sure the way it is
configured is the way the application expects.