Microcode Revision Level C9 for FRU 93H7896 & 52G3380

Contents

Overview

Following is the instructions for updating the firmware (microcode) of the IBM RISC System/6000 SCSI-2 Enhanced Differential Fast/Wide Adapter (4-C) FC 2412 [Corvette Turbo]. The installation of this firmware level is required. The file systems created on disks connecting to the adapter will be temporarily unavailable while the firmware is being updated.

Approximate time for microcode installation:  30 minutes

 Back to Contents


Before Updating the Adapter Firmware

Before updating the adapter firmware, you must follow the instructions below to verify whether or not you have the appropriate level of adapter hardware and firmware in your system.

1)  Issue the following command to list the MCA SCSI adapters installed in the system:

lsdev -C | grep "ascsi"

All installed SCSI adapters will be listed as available. The adapter device names will be in ascsi# format, where # is the numeric logical identification of each adapter device.

2) To check the current microcode level for the adapter enter the following command

lscfg -vl ascsi#

Note the FRU Number and the Loadable Microcode Level fields.  If the FRU Number is 93H7896 or 52G3380 and the Ros Level and ID is less than C9, the system contains the appropriate adapter hardware level and a down-level adapter firmware.  You should update the adapter firmware.

 Back to Contents


Updating the Adapter Firmware

1) Obtain EMT file "corvC9.EXE" or AIX binary file "8EFC3088.C9M"  (if you already have the AIX file skip to step 3)

2) Unpack the EMT file in order to obtain the AIX binary file on diskette

3) With the machine powered on and AIX operating system successfully loaded, follow the instructions below to install the FLASH code onto your SCSI adapters.

4) Log in as root

5) Copy the AIX binary file "8EFC3088.C9M" from diskette into the /etc/microcode directory

6) If the adapter controls the disk containing "rootvg" then you must flash the adapter using standalone diagnostics.... refer to step A.  Otherwise,
continue to step 7.

7) You are now ready to FLASH the EEPROM in the adapter using the single command:

diag -c -d ascsi# -T"download"

Where # is the number found from the "lsdev -C | grep ascsi" command. Repeat the above command for all the cards that need the update.

A) Reboot the machine using the standalone diagnostics CD or diskettes.

B) Select Service Aids -> Microcode Download

C) Select the adapter you update the microcode

D) Select Functional Microcode -> Download the Latest Level of Microcode -> /etc/microcode

E) You have now successfully flashed the adapter.  Repeat steps C & D for all other adapters.Where # is the number found from the "lsdev -C | grep ascsi" command. Repeat the above command for all the cards that need the update.

If you require further instruction refer to the RS/6000 microcode download procedure.

 Back to Contents


Privacy | Legal | Contact IBM