02EB330_029_029
Fix for intermittent false Logic Temperature Sensor SRC
Fix for code update failures to I/O power supplies
Fix for false power supply SRCs during concurrent code update
Fix for the hardware management console (HMC) getting stuck at "Pending Authentication" for the rear Bulk Power Controller (BPC)
Updates to cable error logging
Change to prevent 11008710/11008711 SRCs during code update to an IH DCA (power supply)
Updates to error logging to add a secondary FRU to the list of possible failing hardware
Fix for false SRCs while servicing a Cross-Power Cable
Fix for posting a defective power supply SRC when the fault was a defective fan
Support for posting high/low room temperature SRCs and improved handling of high logic temperature
Fix for internal communication problems in power supplies
Support for low power mode on Air-cooled IH systems
Fix for a missing FRU call-out in some MWU (Modular Water Unit) SRCs
Fix for reversed cable descriptions in power supply SRCs
Fix for code updates to MWUs (Modular Water Units)
Fix for false SRCs during power supply code update
Improved handling of code update of fans and Bulk Power Regulators (BPRs)
Fix for code update failing to run on both Bulk Power Controllers (BPCs)
Fix for failure to power on I/O drawers
Fix for Bulk Power Regulators (BPRs) not recovering properly after line cord removal/replacement
Update to Health Check behavior to prevent HSCF0168E error
Fix for false 14010135 SRC
Fix for false 14012051/14012052 SRCs
Improvement to prevent water flow oscillations in Modular Water Units (MWUs)
Improved handling of water level sensors in Modular Water Units (MWUs)
Improvements to the Fill and Drain Tool
02EB330_017_017
BPC to BPC communication enhancements
BPF fan speed setpoint changes
Fix for false B1868C59 reference codes
Change to memory throttling initiation point
Fix for false 14017195 reference code when UEPO cable is disconnected
Fixes for wrong/missing FRUs in PEL logs
Fixes for problems during code download of power FRUs
Fix for missing I/O drawer after BPC reset or BPC code update
Fix for occasional slow BPC performance
Change to prevent exit from Power Save if power supply fails while in Power Save
Support for new 8.8KW BPR
Improved handling of VRM failures in power supplies
Fix to prevent loss of I/O drawer VPD data during replacement of I/O power supplies
Improvements to the CEC power supply balancing function
02EB330_001_001
Bulk Power Firmware Release for the General Availability of the Power 6 System p 9119 Server (9119-F2A)