|
8.531 bytes |
Service Hints & Tips |
Document ID: RMIE-3FZB78 |
Aptiva - 2136 Product description & components
Applicable to: World-Wide
Product Description
The Machine Type 2136 contains two PCI slots, three ISA slots and one PCI/ISA-shared slot.
The system board supports the Pentium processor and has the following features:
ÀPentium socket 7 Zero Insertion Force (ZIF) connector. You must remove the old processor to install an upgrade processor.
ÀDetachable CPU heat sink with fan.
À16-KB CPU internal cachecachespecification memory
ÀOnboard fixed 256-KB Pipe-Line Burst external cache(PBSRAM).
ÀOnboard fixed 1-MB video Synchronize Graphics RAM(SGRAM).
ÀFour, 72-pin system memorymemory DRAM specification module sockets support these memory modules:
-4-MB, 8-MB, 16-MB, or 32-MB SIMM SIMM specification modules.
-Non-Parity (32-bit) memory SIMMs.
-Memory speed of 60 nanoseconds (ns).
-Tin-lead contacts.
-Support fast page mode or Extended Data Out (EDO) Dynamic Random Access Memory (DRAM).
-Maximum system board memory is 128 MB. Refer to "SIMM Configurations " on page 5-14.
ÀPortshardware interfacesports for
-Video port (15-pin D-sub connector)
-Parallel port (25-pin D-sub connector)
-Two serial ports (9-pin D-sub connector)
-Keyboard port (PS/2 connector)
-Mouse port (PS/2 connector)
ÀConnectors for hardware interfaceconnectors
-PCI/ISA riser card (1x186-pin)
-Input power (12-pin)
-AT diskette drive (34-pin)
-Two 40-pin Enhanced IDE drive channels: a primary local bus IDE that supports two hard diskhard disksignal and LED cables drives and a secondary Enhanced IDE that supports a CD-ROM drive and one hard disk drive, or two hard disk drives.
-2-wire power Light-Emitting Diode (LED) cable
-4-wire hard disk Light-Emitting Diode (LED) cable
-2-wire power switch connector cable
-3-wire power supply auxiliary control connector from power supply to system board for Microsoft Windows 95 software shutdown feature.
-RTC lithium battery.
Processors
ÀOne of the following processors can be installed:
-Pentium P54C-133 MHz internal; 66 MHz externalprocessorsPentium P54C-133 MHz
-Pentium P54C-150 MHz internal; 60 MHz external processorsPentium P54C-150 MHz
-Pentium P54C-166 MHz internal; 66 MHz external processorsPentium P54C-166 MHz
-Pentium P54C-200 MHz internal; 66 MHz external processorsPentium P54C-200 MHz
-Intel/Cyrix P150+ processor
-Intel/Cyrix P166+ processor
Diskette specification Drive
ÀAT-type
À3.5-in. 1.44 MB slimline diskette drive.
Multimedia system specification
ÀOnboard 5.25-in. high-performance, eight-speed (8X) or twelve-speed (12X) CD-ROM IDE/AT drive that can read data and play audio from standard and mini CD-ROM and audio compact discs (audio CDs). It is compatible with industry-standard multimedia requirements.
ÀAudio-I/O card (either of with or without wave table feature).
ÀFax/modem adapter card with fax send/receive, voice-over-data features,
ÀOne pair of external speakers with power adapter.
ÀExternal microphone.
Power management specification
ÀEnable/disable power saving feature by BIOS Setup Utility.
ÀDevices (monitor and hard disk drive) power saving control by BIOS timer setup.
ÀSystem (standby and suspend modes) power saving control by BIOS timer setup.
Power Supply specification
ÀThe power supply is a 200-W switchable high/low voltage power supply with a thermal sensing variable fan speed and a connector for a detachable grounded 3-wire power cord.
ÀThe power cable has four DASD connectors: one mini power connector and three standard 4-pin connectors.
ÀTo support the Microsoft Windows 95 software shutdown feature, all power supplies have a 3-wire auxiliary control cable that connects to the system board. There is no on/off switch cable assembly for the power supply.
Cables
ÀTwo 40-pin ribbon cable for hard disk drives and CD-ROM
ÀOne 34-pin ribbon cable for diskettediskettesignal and LED cables drive
ÀOne 3-pin auxiliary power control cable from power supply to system board
ÀOne 4-pin (2-wire) HDD LED cable from system board to front panel
ÀOne 3-pin (2-wire) power LED cable from system board to front panel
ÀOne 2-pin (2-wire) power switch cable from system board to front panel
ÀOne 4-pin voice signal cable from system board to fax/modem adapter card
ÀOne 10-pin and one 34-pin ribbon cable from system board to Audio-I/O card.
Hard Disk drive specification
ÀThe hard disk drive is a 3.5-in. low profile, 1-in. height IDE AT drive with "look-ahead" 128 KB cachecachein hard disk drive memory and a minimum of 12ms average seek time. Access time varies by the hard disk drive and the hard disk drive manufacturer.
Monitors
À14/15 in SVGA (Super Video Graphics Array) monitors include:
-0.28-mm dot pitch.
-Automatic scanning horizontal frequencies from 30KHz to 54KHz and all vertical frequencies between 50Hz and 100Hz.
-Up to nine user controls: power, contrast, brightness, horizontal center, vertical center, horizontal size, vertical size, pincushion
-Auto-sensing power input for 100 Vac to 240 Vac.
-With DDC2A/B feature
-Suspend and off modes with amber indicator blinking.
-Power switch.
-Tilt and swivel base
-Connector for a detachable grounded 3-wire power cord.
-1.8-m (5.8-ft) attached signal cable.
Keyboard specification
À104-key, or 105-key rubber dome keyboard with 1.8-m (6-foot) cable.
Mouse specification
PS/2 mouse with 1.8-m (6-foot) cable
|
Search Keywords |
| |
|
Hint Category |
Technical Specifications | |
|
Date Created |
10-04-97 | |
|
Last Updated |
10-03-99 | |
|
Revision Date |
10-03-2000 | |
|
Brand |
IBM Aptiva | |
|
Product Family |
Aptiva | |
|
Machine Type |
2136 | |
|
Model |
| |
|
TypeModel |
| |
|
Retain Tip (if applicable) |
| |
|
Reverse Doclinks |