|
22.797 bytes |
Service Hints & Tips |
Document ID: PMYS-3KYH6B |
Aptiva - 2140/2142 Removals and replacements - lithium battery
Applicable to: China, Hong Kong, Japan, Australia, Canada, Denmark, Finland, France, Germany, Italy, Netherlands, Norway, Spain, Sweden, United Kingdom, United States
Adapter cards if applicable.
Insert the tip of a screwdriver (1) under the clip and raise the clip (2) carefully to remove the battery.
The lithium battery can cause a fire, explosion, or severe burn. Do not recharge it, remove its polarized connector, disassemble it, heat it above 100›C (212›F), incinerate it, or expose its cell contents to water. Dispose of the battery as required by local ordinances or regulations.
Use only the battery in the appropriate parts listing. Use of an incorrect battery can result in ignition or explosion of the battery.
Attention: Be careful when removing the battery. If the retaining clip is broken, the system board must be replaced.
Note: Run the Setup Utility after installing a battery.
Lithium battery
|
Search Keywords |
| |
|
Hint Category |
Power, System Boards, Hardware Installation/Configuration | |
|
Date Created |
15-08-97 | |
|
Last Updated |
08-01-99 | |
|
Revision Date |
08-01-2000 | |
|
Brand |
IBM Aptiva | |
|
Product Family |
Aptiva | |
|
Machine Type |
2140, 2142 | |
|
Model |
All | |
|
TypeModel |
| |
|
Retain Tip (if applicable) |
| |
|
Reverse Doclinks |