|
29.792 bytes |
Service Hints & Tips |
Document ID: JWOE-3KXL37 |
Aptiva - 2140/2142 CD/DVD-ROM drive jumper settings
Applicable to: United States, Canada, Japan, Italy, United Kingdom, France, Germany, China, Hong Kong, Denmark, Spain, Netherlands, Sweden, Norway, Australia, Finland
The CD/DVD-ROM drives are connected to the system board secondary drive connector at the factory. CD/DVD-ROM drive jumpers are set as the master drive, as shown in Figure 5-11. If an additional hard disk drive is connected to the secondary connector, it must be set as the master drive (see 1 in figure 5-7) and the CD/DVD-ROM drive jumpers reset as the slave drive as shown in Figure 5-11.
Note: For models that have a factory-installed Zip drive, the Zip drive is jumpered as slave and the CD/DVD-ROM drive is jumpered as master.
Check the Setup Utility for correct installation.
CD/DVD-ROM Rear View
Figure 5-11. CD/DVD-ROM Drive Jumper Settings
|
Search Keywords |
| |
|
Hint Category |
Hardware Installation/Configuration, CD-ROM Drives, DVD Drives, Jumper/Switch Settings | |
|
Date Created |
14-08-97 | |
|
Last Updated |
11-01-99 | |
|
Revision Date |
11-01-2000 | |
|
Brand |
IBM Aptiva | |
|
Product Family |
Aptiva | |
|
Machine Type |
2140, 2142 | |
|
Model |
All | |
|
TypeModel |
| |
|
Retain Tip (if applicable) |
| |
|
Reverse Doclinks |
Yes |