H132814 - "Path not found" Error Running IBMSETUP on PC 700 SYMPTOM: IBM PC 700 Series 6877 and 6887 systems preloaded with DOS and Windows 3.11 may exhibit a "Path not found" error when performing "IBMSETUP." PROBLEM ISOLATION AIDS: When using the RTC (Ready to Configure) CDROM to create LAN Image diskettes, all files are not copied to the diskette. The system returns to the main menu with no error message posted. This ONLY affects the LAN Image diskette creation process. When IBMSETUP is run from the LAN Image diskette created in the step above, a "Path not found" message will be displayed. The IBMRTC directory on the diskette contains only 8 files, but should have a total of 16 files. FIX: To eliminate this problem, perform the following steps in the sequence given: 1) Create CDROM drivers from the Diskette Factory of RTC. 2) Remove the CDROM drivers from the CONFIG.SYS and AUTOEXEC.BAT files from the system hard file. 3) Reboot the system. The CDROM drivers should NOT load. 4) Install the CDROM drivers using the diskette created in step #1 using the "A:CDSETUP" command. 5) The following lines should appear in the CONFIG.SYS and AUTOEXEC.BAT files: AUTOEXEC.BAT- "LH C:\DOS\MSCDEX /D:IBMCD001 /M:10" CONFIG.SYS - "DEVICEHIGH=C:\CDROM\IBMIDECD.SYS /D:IBMCD001" 6) Reboot the system. 7) The LAN Image diskettes may be re-created from the RTC CD.