IBM eServer 326 Flash Update Version 1.25 Build M2E125A CHANGE HISTORY ______________ BIOS Version 1.25 - Build M2E125A - Fixed problem with mouse and keyboard not function properly while running Windows Server 2003 SP1 x64 BIOS Version 1.24 - Build M2E124A - Support enabling node interleave mode when Memory Hole was Software. - Fixed serial connection that can not established under OS installed - Fixed wrong event log of memory change on BIOS setup. BIOS Version 1.23 - Build M2E123A - Fixed inconsistences between the SEL and LEDs Lightpath in the reporting on which pair of Dimms caused the Multiple Bit ECC error. - Added a delay in the scrubber initialization routine at Post that prevents the reporting of Multiple Bit and ECC chipkill errors during initialization time when eight 2.0G DIMMs are installed. - Added automatic detection of CPU type. When Bios detects rev CG CPU "Memhole Mapping" default will be set to [SW]. When Bios detects rev E CPU "Memhole Mapping" default will be set to [HW]. Benefits of memory hoisting either "software" or Hardware as used on the AMD processor is to re-allocate the memory map to above the 4G region. This allows the system to have access to the full 4G region that would normally be allocated to a device like a PCI adapters. - Fixed false reporting of Dimm's 7 & 8 when a Multiple Bit ECC error occurs on Dimms other than Dimm's 7 and 8. BIOS Version 1.22 - Build M2E122A - Added new micro code to fix AMD errata #131 - Fixed DIMM7/DIMM8 Error LED always on when multi-bit ECC install DIMM1/2 or DIMM3/4 and power on/off 2 times - Fixed system cannot backup BIOS image to USB FDD with phoenix flash utility - Supported AMD BIOS check v2.1.3 BIOS Version 1.21 - Build M2E121A - Corrected an issue where you could not boot to a SCSI Hard Drive attached to a Serve Raid 6M card if the USB Floppy Diskette Drive was not installed. - Corrected an issue which prevented logging of a double bit ECC memory error. - Added new code to fix AMD errata #123 which could cause the system hang. BIOS Version 1.20 - Build M2E120A - Updated new code base for dual core AMD K8 power now function. - Fixed the boot process allowing system to show F1 Setup prompt. - Fixed ECC LED function fail during Runtime. BIOS Version 1.19 - Build M2E119A - Removed F1 message after ROM scan to cover the time delay issue in RSA remote console - Implemented 12.4.3 command to RSA while bad dimm/serr/perr detected - Supported Dual code CPU string. - Fixed AMD errata 1.22. BIOS Version 1.18 - Build M2E118A - Fixed USB CDROM boot failure when USB floppy was not attached. - Updated SATA option ROM to version 4.3.534. BIOS Version 1.16 - Build M2E116A - Added revision E processor support BIOS Version 1.11 - Build M2E111A - Fixed DMI table issues for IPMI drivers - Td enhancement with offset value feedback to BMC - Single bit error (SBE) algorithm updated - BMC FW 1.10 required to enable SBE and Td enhancements BIOS Version 1.10 - Build M2E110A - Enhance PCI error detection - Add IBM RDM support for wake on lan - Corrected display of run-time double bit errors BIOS Version 1.09 - Build M2E109A - Fixed AMD BIOSCheck 1.4.1 issue - Enhanced runtime multibit error logging BIOS Version 1.08 - Build M2E108A - Initial release