Installing the hub To install the hub: 1. Turn on the computer. 2. Insert the IBM Multi-Port USB Hub Option Diskette into the diskette drive. (Insert your Windows 98 installation CD into the CD-ROM drive if you are prompted to do so by the on-screen instructions. If you do not have a CD-ROM drive, insert the first Windows 98 installation diskette into the diskette drive.) 3. Insert the barrel connector at the end of the ac/dc power adapter into the power-adapter connector on the rear of the hub 1 ; then connect the other end of the cord to an electrical outlet. 4. Connect one end of the two-foot USB cable to the computer USB connector and the other end of the cable to the USB cable connector on the front of the hub 2 . The Add New Hardware wizard window opens and displays a message that it detects a generic USB hub device driver. To add the hub device driver: 1. Click Next. 2. Select Search for the best driver for your device. 3. Click Next. 4. Select Floppy disk drives. 5. Click Next. 6. Select The updated driver (Recommended). 7. Click Next twice. 8. Click Finish. The Add New Hardware wizard window opens and displays a message that it detects the IBM USB-Parallel Converter. To add the IBM USB-Parallel converter device driver: 1. Click Next. 2. Select Search for the best driver for your device. 3. Click Next. 4. Select Floppy disk drives. 5. Click Next twice. 6. Click Finish. The Add New Hardware wizard window opens and displays a message that it detects a USB Human Interface Device. To add the USB human interface device driver: 1. Click Next. 2. Select Search for the best driver for your device. 3. Click Next. 4. Select Floppy disk drives. 5. Click Next twice. 6. Click Finish. The Add New Hardware wizard window opens and displays a message that it detects the IBM USB Serial Converter. To add the IBM USB serial converter device driver: 1. Click Next. 2. Select Search for the best driver for your device. 3. Click Next. 4. Click Floppy disk drives. 5. Click Next twice. 6. Click Finish. If the Add New Hardware wizard window opens, complete the installation by using the following instructions. a. Click Next twice. b. Click Finish. To uninstall the hub device drivers: 1. Disconnect the hub from the computer. For information on disconnecting the hub, go to Disconnecting and reconnecting the hub on page 1-7. 2. Insert the IBM Multi-Port USB Hub Option Diskette into the diskette drive. 3. Click Start. 4. Select Run. 5. Click the Browse.... button. 6. Select the diskette drive (a:\) from the Look in pull-down menu. 7. Double-click Uninst.exe. 8. Click Yes to confirm uninstallation. 9. Click Yes to restart your computer.