IBM ThinkPad 770X
System Program Service Diskette for use with 
Intense 3D 3400T graphics accelerator card 
installed in the SelectaDock III.
============================================


What This Diskette Does
-----------------------

The System Program Service Diskette given here can update the system
program stored in the ThinkPad system to fix problems, add new functions,
or expand functions. The supported models are as follows.

   - ThinkPad 770X

This BIOS level has been released and tested by IBM to support only the
770X models (9549-7AU/7BU/71U/72U) of ThinkPads.

Use is limited to support for the Intense 3D 3400T graphics accelerator card 
in the IBM SelectaDock III when running in a Windows NT 4.0 (r) environment.  
No additional adapters or option combinations should be used with this level 
of BIOS. Only the graphics accelerator card listed above is supported.  IBM 
does not plan any additional changes or updates to this level of BIOS for 
future releases of the Intense 3D 3400T graphics accelerator.  For all other 
configurations of the ThinkPad 770X and SelectaDock III, users should go to 
the IBM support page for the latest 770X BIOS updates.


To update the system program, please refer to the "Updating System
Program" section.


Updating System Program
-----------------------

Notes: - You need an AC adapter and a charged battery pack to update
         the system program.

       - If your computer is attached to any kinds of Docking station
         or port replicator, turn off the computer and detach it before
         proceeding.

1.  Print these instructions or display on another computer.
2.  Firmly connect the AC adapter to the computer.
3.  Insert the System Program Service Diskette into the diskette drive
    and turn on the computer.
4.  Select "Read this first..." from the menu and carefully read the
    information that appears.
5.  Press the ESC key to return to the menu.
6.  Select "Update system program" and follow the instruction on
    the screen.

    Warning: Do not turn off or suspend the computer until the update
             has been completed. IF YOU TURN OFF OR SUSPEND THE
             COMPUTER WHILE THE UPDATE IS STILL IN PROGRESS, THE SYSTEM
             BOARD MAY HAVE TO BE REPLACED.

After the update has been completed, do the following to make the
changes effective.

7.  Make sure the System Program Service Diskette is removed from
    the diskette drive, then turn off the computer.
8.  Press and hold the F1 key, then turn on the computer. Hold the F1 key
    until the Easy-Setup menu appears.
9.  If a password prompt appears, type the correct password.
10. Select Config, then select Initialize.
11. Select OK to initialize the system.

Run the diagnostics to make sure that the computer runs with no errors:

12. Turn off the computer, press and hold the F1 key, then turn on
    the computer. Hold the F1 key until the Easy-Setup menu appears.
13. Select Test, then select Start to run all the basic tests.
    Various test patterns will appear on the screen.
    An OK will appear for each device that passes the test.
14. Verify that OK appears for all of the devices tested.
15. Press the ESC key to exit Test and turn off the computer.