Instructions to install the Sytos Plus DOS IBM 2.3GB Tape Driver (IBG_23GI.DRV, Driver Rev. 1.12). Replace the current device driver with the new driver before making any changes to the system hardware. If Sytos Plus has already been installed and backups have been run using the IBM 2.3GB tape drive, copy the new device driver onto the fixed disk. The instructions below use the Sytos Plus default directory name on drive C:. 1. Change to the SYFILES directory under the directory where Sytos Plus was installed by typing: C: CD \SYPLUS\SYFILES 2. Insert the diskette with the DOS IBM 2.3GB Tape Driver into drive A. 3. Verify that the driver is in the root directory on the diskette by typing: DIR A:\ The driver file is named IBG_23GI.DRV. 4. From the SYFILES directory on C: drive, type: COPY A:\*.DRV /V 5. Change back to the C:\SYPLUS directory by typing: CD .. 6. Verify that the driver was copied correctly by typing: TYPE SYFILES\IBG_23GI.DRV The last line displayed should be: Software Revision 1.12 1/24/92. 7. Run Sytos Plus to verify that Sytos Plus is functional before making any changes to the system. From the Sytos Plus Utilities menu, select Volumes..., insert a cartridge with a Sytos Plus backup, and choose . Sytos Plus will read volume information from the cartridge. 8. Exit Sytos Plus. 9. Contact Sytron Customer Service to obtain the Sytos Plus DOS IBM 2.3GB Tape driver diskette. Should you need to re- install Sytos Plus, follow the instructions in the README on the driver diskette. If Sytos Plus has not been installed, contact Sytron Customer Service to obtain the Sytos Plus DOS IBM 2.3GB Tape driver diskette. Should you need to re-install Sytos Plus, follow the instructions in the README on the driver diskette Please contact Sytron Customer Service by mail or by fax. Provide your name and address and refer to Sytron P/N 06246. By mail: Sytron Corporation Attn: Customer Service P.O. Box 5025 Westboro, MA 01581-5025 By fax: (508) 898-2677