IBM ISA CDROM INSTALLATION FOR OS/2 2.1 To properly install this drive you will need the following: 1. The switch settings on the interface card. refer to your cd-rom manual. 2. The diskette with the ISACDOS2.ADD driver. 3. The os/2 diskettes or the CDROM install package. FOR INSTALLATION OF OS/2 2.1 1. Make a dsikcopy os OS/2 disk1. 2. Edit the config.sys and add the device driver line. BASEDEV=ISACDOS2.ADD /M:xxx where xxx is the hex address set on the switches. 3. Start the installation. AFTER OS/2 IS INSTALLED 1. Open the OS/2 system icon. 2. Open Command Prompts. 3. Open OS/2 WINDOW. 4. Type E config.sys 5. Add the line BASEDEV=ISACDOS2.ADD /M:xxx Where xxx is the hex address set on the switches. 6. Save and exit. 7. Type exit. 8. Close Command Prompts. 9. Select System Setup. 10. Select Selective Install. 11. Put a check mark in the CDROM Box. 12. Click on OK. 13. This will bring up a list of CDROMS. Select OTHER. 14. Follow the online instructions for the driver installation. 15. Shut Down and Reboot. Check the Drives Icon for the presence of your CDROM.