Enter SCU
Menu Options
Startup
Disks
Components
Power
Exit
Enter SCU
During boot, right after "Autodetecting IDE Devices" the SCU
prompt will come up for maybe 5-10 seconds (you snooze, you loose). The
exact prompt is "<CTRL+ALT+S> to enter
System
Configuration Utility."
Menu Options
Startup Disks Components Power Exit
Startup
Date and Time
Boot Device
A or C
Cache System
Disable, L1 Enabled (not a choice in BIOS 1.25), Write Thru
Color Scheme
Default, Alternate, Monochrome, Inverse Mono
Disks
_Internal FDC
Yes / No
Diskette Drive
None, 1.44MB, 2.88MB
IDE Settings
Multiple Sector Mode Yes / No
_Boot Sector
Change Possible boot sector write protection?
Components
Com Ports
ComA (DE9 Port)
None, Com1 (3F8-IRQ4), Com2 (2F8, IRQ3)
ComB (DE9 on Cradle)
None, Com1 (3F8-IRQ4), Com2 (2F8, IRQ3)
Com3 (internal
modem) IRQ 4 or IRQ 11
Com4 (wireless
modem) IRQ 3 or IRQ 10
LPT Port (Standard, PS/2,
EPP, ECP)
Port Address
None, 378h/IRQ7, 378h/IRQ5, 278h/IRQ5, 3BCh/IRQ7
Port
Definition for 3BCh Standard AT (Centronics), Bidirectional
(PS-2)
Port
Definition for 378h or 278h Standard AT (Centronics), Bidirectional
(PS-2)
Enhanced Parallel (EPP), Extended Capabilities Parallel (ECP)
EPP/ECP
Version v 1.7 or v 1.9 (available for 378 / 278 addresses only)
_Keyboard Numlock
Keyboard Repeat Repeat
Rate (typematic), Key Delay
ISA Expansion Huh?
External slots?
Power
Enable Power Sharing Yes
/ No (If No, the Standby and Suspend Options are unavailable)
Standby Control Disk
Timeout (Disabled to 5min), Backlight Timeout (Disabled to 15min)
Com1 Timeout (Disabled to 15min), CPU
Doze Throttle (Enable/Disable)
Suspend/Resume Control Suspend Timeout
(Never - 30min)
Low Gas Guage
Warning (0-25%)
Suspend on Low
Battery (Yes/No)
Suspend on AC
Power (Yes/No) Allow automatic suspending while on external
power.
Resume on RTC
Alarm (Yes/No)
Resume Hour (0-23)
Resume
Minute (0-59)
Resume on Radio
Modem (Yes/No) Com1 ring always causes resume.The internal
modem
cannot because it
is powered off or suspended)
Exit
Exit (No Save)
Save and Reboot
Default Settings
Factory Settings
Version Info
|