1. CAUTION: When
you tilt out the power supply, do not let it drop. Personal injury
or damage to the server might result.
Tilt out the power supply:
a. Disconnect drive power cables from
the power supply.
b. Unscrew the blue spring-loaded retaining
knob until it releases.
c. Place one hand on top of the server
to support it.
d. Tilt out PSU with the other hand.
(Be sure the AC power cord is removed from the server before you try to
tilt out the power supply.)
2. SIMMs must be installed in pairs of the same size, speed, and
type. All memory installed must be of the same type (either parity or ECC).
Install SIMMs in the following order: A1-B1, A2-B2, A3-B3, A4-B4.
A and B Bank Layouts
3. Touch the static-protective package to any unpainted
metal surface on the server. Then, remove the SIMM from the package.
4. Reinstall the power supply:
Move the cables out of the way.
NOTE! If you have a SCSI CD rom
with an external terminator on it in the single 5.25" bay, this is referred
to as a "guillotine"! Carefully push the SCSI cable towards the front of
the case while rotating the power supply back in. Or you WILL
Tilt the power supply into the server.
Press in the retaining knob and turn it to the right until it is tight.
Reconnect the twisted power cables to the power supply.
9595 Main Page