AdapterId 06e6ch AdapterName "M-ACPA/A" NumBytes 1 NamedItem Prompt "Address Selection" choice "FDC0-FDC7" pos[0]=xxxxx001b io 0fdc0h-0fdc7h choice "FDC8-FDCF" pos[0]=xxxxx011b io 0fdc8h-0fdcfh choice "FDD0-FDD7" pos[0]=xxxxx101b io 0fdd0h-0fdd7h choice "FDD8-FDDF" pos[0]=xxxxx111b io 0fdd8h-0fddfh choice "Disable" pos[0]=xxxxxxx0b Help "The base address of the M-ACPA/A can be at one of 4 different locations. Choose a location which does not conflict with any other installed board. 'Disable' will cause the M-ACPA/A to not be available. This assignment need only be changed if it is in conflict with another board. Conflicting assignments are marked with an asterisk. Use the F5=Previous and the F6=Next keys to change address selection when you are in the 'Change configuration' window." NamedItem Prompt "Interrupt Selection" choice "Interrupt 3" pos[0]=xx000xxxb int 3 choice "Interrupt 4" pos[0]=xx001xxxb int 4 choice "Interrupt 5" pos[0]=xx010xxxb int 5 choice "Interrupt 6" pos[0]=xx011xxxb int 6 choice "Interrupt 9" pos[0]=xx100xxxb int 9 choice "Interrupt 10" pos[0]=xx101xxxb int 10 choice "Interrupt 11" pos[0]=xx110xxxb int 11 choice "Interrupt 12" pos[0]=xx111xxxb int 12 Help "The interupt select chooses which interrupt level the M-ACPA/A will use for interrupts. Minimize the amount of interrupt sharing by assigning other installed boards to different levels. Conflicting assignments are marked with an asterisk. Use the F5=Previous and the F6=Next keys to change the interrupt level selection if you are in the 'Change configuration' window."