;Future Domain Corporation ;IBM Coropration ;ADF File for MCS-700 board/IBM MC SCSI-2 adapter (18C50 VLSI) ;Version 1.2 ;01/10/94 6620429 SBB remove inturrupt 12, move int14 to end of list. ; AdapterID 060E9h AdapterName "IBM Personal System/2 SCSI-2 Adapter/A" NumBytes 2 FixedResources pos[1]=0000xxxxb nameditem Prompt "Adapter ROM BIOS Address" Choice "Segment CA00" pos[0]=01xxxxxxb pos[1]=xxxxxx00b mem 0ca000h-0cbfffh Choice "Segment CE00" pos[0]=10xxxxxxb pos[1]=xxxxxx00b mem 0ce000h-0cffffh Choice "Segment DE00" pos[0]=11xxxxxxb pos[1]=xxxxxx00b mem 0de000h-0dffffh Choice "Segment C800" pos[0]=00xxxxxxb pos[1]=xxxxxx00b mem 0c8000h-0c9fffh Choice "Disabled" pos[1]=xxxxxx11b Help "To configure this adapter you must choose the memory address the adapter will use for it's ROM BIOS. There are four memory addresses that may be selected from. Under normal circumstances, select . If a conflict occurs, choose another memory address. In general, the BIOS must be enabled to support fixed or removable SCSI disk drives. If you are using the PowerSCSI software, and if the only SCSI devices attached to this controller are tapes, CD-ROM drives or non-direct access devices, the BIOS may be disabled to speed system startup." nameditem Prompt "Adapter I/O Port Address" Choice "0140h" pos[0]=xx00xxxxb io 0140h-014fh Choice "0150h" pos[0]=xx01xxxxb io 0150h-015fh Choice "0160h" pos[0]=xx10xxxxb io 0160h-016fh Choice "0170h" pos[0]=xx11xxxxb io 0170h-017fh Help "Choose the I/O port addresses the adapter will use. There are four I/O port addresses that may be selected from. Under normal circumstances, select <0140h>." nameditem Prompt "SCSI Adapter Address (ID)" Choice "7" pos[1]=xxxxxxxxb Help "This is the SCSI ID of the adapter. This value is fixed and cannot be changed." nameditem Prompt "Select Interrupt Line" Choice "IRQ 5" pos[0]=xxxx001xb int 5 Choice "IRQ 10" pos[0]=xxxx010xb int 10 Choice "IRQ 11" pos[0]=xxxx011xb int 11 Choice "IRQ 15" pos[0]=xxxx110xb int 15 Choice "IRQ 3" pos[0]=xxxx000xb int 3 Choice "IRQ 14" pos[0]=xxxx101xb int 14 Choice "Disabled" pos[0]=xxxx111xb Help "Select the interrupt to be used by the SCSI controller. Under normal circumstances, select ."