Unknown FLASH id 55aa


PROBLEM - Valuepoint 6381 SX and DX systems may display the following message when attempting to install FLASH BIOS:

"unknown FLASH ID 55AA"
"check jumper 03"

Machines AFFECTED - Valuepoint 6381 SX and DX systems.

SOLUTION - Move the FLASH enable jumper from PINs 2 and 3 to PINs 1 and 2 (rear 2 PINs) and continue with FLASH installation per the instructions in "readme.fil".

If the 2-pin jumper is missing, order jumper FRU P/N 93F0067 (2 position-4 pack).

Inspect the system board for the following jumper: SX models - J11 or DX models - J10

If this jumper location is present, this tip applies.


Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.