Module test menu and hardware configuration report
Module test menu and hardware configuration report
Depending on the diagnostics version level you are using, the installed devices in the computer are verified in one of
two ways:
- At the start of the diagnostic tests, the Module Test Menu is displayed.
Normally, all installed devices in the computer are highlighted on the menu.
- At the start of the diagnostic tests, the main menu appears.
From this menu, select System Info then select Hardware Configuration from the next menu.
Normally, all installed devices in the computer are highlighted on this report.
If an installed device is not recognized by the diagnostics program:
- The diagnostic code for the device is not on the diagnostic diskette.
Run the diagnostics provided with that device.
- The missing device is defective or it requires an additional diskette or service manual.
- An unrecognizable device is installed.
- A defective device is causing another device not to be recognized.
- The SCSI controller failed (on the system board or SCSI adapter).
- Use the procedure in
Undetermined Problems
to find the problem.
If a device is missing from the list, replace it. If this does not correct the problem, use the procedure in
Undetermined Problems.
Please see the LEGAL - Trademark notice.
Feel free - send a
for any BUG on this page found - Thank you.