Installing the SNMP Agent in Windows 95 and Windows 98

Installing the SNMP Agent in Windows 95 and Windows 98

Use this procedure to install the SNMP Agent after the UMA program has been installed.
This procedure is not required if the SNMP Agent was installed as part of the UMA program installation.

  1.  From the Windows Desktop, click on Start, select Settings, and then click on Control Panel.
  2.  Double click on the Network icon.
  3.  Click on Add.
  4.  Click on Service, and then click on Add.
  5.  Click on Have Disk.
  6.  Insert the Windows 95 or Windows 98 CD into the CD-ROM drive.
  7.  Click on Browse.
  8.  Use the following information to locate the SNMP directory on your Windows 95 or Windows 98 CD.

  9.  Click on snmp.inf.
  10.  Click on OK. The Install From Disk window appears.
  11.  Click on OK. The Select Network Service window appears.
  12.  Click on OK to complete the network setup, and then close the Network window.

The SNMP Agent is now installed. You must now manually add the trap destinations and community names to the registry using the REGEDIT program. See 'Windows 95 and 98 Registry Entries for SNMP' later in this section for details.

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.